Tutorials Fix a USB flash drive after use by Win32 Disk Imager

[Mr. Spacely]

This short article provides instructions on how to recover the full capacity of a USB flash drive following use with the Win32 Disk Imager software.

Fix instructions

Win32 Disk Imager is a great tool for taking an ISO disc image and writing it to a USB flash drive so that you can install an Operating System such as Linux on another PC without needing an optical drive or to waste a DVDR disc.

However, one disadvantge with using this tool is that it tends to mess up the USB flash drive.

If you try to reformat it using Windows or Linux chances are it will only format a portion of the drive leaving you with a much smaller capacity than you started with.

The following instructions will show you how to resolve this problem, restoring your USB Flash Drive to its former capacity.​

1. Run CMD in Windows as an Administrator
2. Type: diskpart
3. Type: list disk
4. Note the number assigned to your disk and replace X in the next command with that number
5. Type: select disk X
6. Type: clean
7. Type: create partition primary
8. Type: active
9. Type: format fs=fat32 label="PENDRIVE"
10. The above command may take some time depending on the capacity of your drive
11. Type: assign
12. Type: exit
13. Safely eject the USB flash drive
14. Test it and check Properties to confirm original capacity now restored

Thanks to @Spitfire400

 

[edge37]

Thank you

 

[SlavkoPejic]

Thanks

 

[KooMulee]

Thank you.

 

[Hey guddu]

Wow......nice post

 

[Anonymous_yoda]

thanks for the post .. i thought just by formatting it normally (both partitions in the USB) i gain back the whole storage capacity. but after testing this i realized it is better. thanks lad.